The Splitfire. It's one hell of a sidearm. However, no sidearm is complete without a good holster! Here's mine. A lot of people have made holsters similar to this one, but there aren't many pics of 'em. 

Cut some thick wire from a coat hanger and shape it to fit around the top corner of the gun. 

Wrap it in duct tape.

Now, grab some thin cloth and put it on the inside of the wire (always keep the holster on the gun when making it). Apply duct tape.

Put a bit of cardboard on each side of the holster, and duct tape the pieces down. 

No, you're not done yet. Well, if you don't care about the pump wiggling around and coming out when you run, then it's done. But if you want it to stay still, then no, you're not done (work harder!). Cut some more wire and shape it so it can just sort of hang off the end of the holster, as shown. 

And cut a bit of cardboard to go with it, and duct tape 'em on!

If the tab rattles a little, reienforce it with some hot glue, and wallah! You're done. Now you just need to make a harness for it. I'll send Yakman some pics of my harness once I'm done. 

There. 

Thanks, 
Gregg

Thanks Gregg! They are great pics. I envy him his camera. The pics were 2.2 mb as he sent them to me :). The res was 1280x1024--a lot better than my camera. I'm still awaiting info on his harness, and I look forward to seeing it!