| At first I said this mod sucked. But actually, I think my LnL
just sucked. It's important, after doing this mod, to replace
the spring in the LnL and put rubber bands on it. I used the
spring from a Chainblazer; the Chainblazer spring works very
well and is a popular replacement. The PVC makes the gun more
accurate, and I am having my doubts as to whether it decreases
range. I think it doesn't hurt your range that much.
But, I want to warn you that the mod is tough because I don't
have pics of all of it. Make SURE you replace the spring, or
your gun will suck.
If you think you have the m4d sk1LLz, here it is...
Ahh, simplicity at its best. The inside of the LnL.
There is a hidden screw on the non-screw side of the gun, make
sure you remove it.
The innards of the gun. I left the catch spring and mechanism in
so you can see how it goes. The ramped part should be facing
forward.
Cut a small piece of 1/2" sched 40 PVC to about an inch
longer than the original barrel. Cut off the original barrel
where it gets larger and duct tape your new one on. Don't use
too much duct tape, or it won't fit in the case.
Put it all back in the case. Push the spring in and put the
catch mechanism back. Put the trigger on.
Case closed.
The next part shows what to cut off your gun. This part, I
think, is OK to do (it won't mess with your range) and it makes
the gun a little easier to holster.
The original case. We are gonna cut off the black knob coming
off the trigger guard and the triangular thing on the top of the
gun.
After cutting. I covered the holes with a little electrical
tape. I also cut my barrel at a 45* angle; this is bad. Don't do
that :). Make sure you replace the spring and put plenty of
rubber bands on.
|
